fbpx bloglovinBloglovin iconCombined ShapeCreated with Sketch. Fill 1Created with Sketch. Fill 1Created with Sketch. Fill 1Created with Sketch. Fill 1Created with Sketch. Fill 1Created with Sketch. rssRSS iconsoundcloudSoundCloud iconFill 1Created with Sketch. Fill 1Created with Sketch. Fill 1Created with Sketch. Fill 1Created with Sketch. SearchCreated with Lunacy Search iconCreated with Sketch.

A History of Wood Floors

Hand hewn plank floor similar to the first forms of wood flooring.

History

Flooring, just like everything else in the home had very humble beginnings. Only the wealthy had something other than dirt, and that was typically slate or other local stones. Royalty were the first to enjoy the comforts of wood floors. These first wood floors were hand-scraped and literally “sanded.” The workers would lay down rough hand-hewn timbers and use hand tools to scrape smooth the flooring before bringing in handfuls of sand that they would rub on the floors until they were as smooth as possible. It was an arduous task that only the richest could afford.

However, things in the New World were different. Service Seminararbeit schreiben lassen in a scientific study described that the abundance of wood led to the widespread use of wood floors in the masses during the colonial era (1607-1780). At last the new Americans could get off the earthen floors and enjoy the resiliency and warmth of wooden floors.

In some ways, flooring has changed a lot since its earliest days and in other ways it has remained much the same. From 1800-1945 wood floors were available in local species of trees and were installed in relatively simple patterns except for the ultra rich. When it came to residential flooring wood was king for these years. Competing only with tile or linoleum in the bathrooms and kitchens. The cost of wall to wall carpeting was still prohibitively high.

After WWII everything changed and hardwood flooring began a three decades decline. Carpeting became cheap with the advent of synthetic fibers and hardwood was deemed “outdated.” It wasn’t until the 1990s that hardwood floors began to rise in prominence again. The introduction of engineered wood floors made wood more affordable, even if it is a less than stellar product. And recently, homeowners have begun to rediscover solid hardwood floors and their many benefits.

Finishes

In the beginning flooring wasn’t finished. It was worn smooth by generations of foot traffic. There were several ways that wood flooring was finished in the old days, and none of them were particularly effective or long lasting. Floors had to stand up to lots of foot traffic bringing in dirt, sand, and water which all served to wear away the flooring.

  • Wax – Waxing was a early form of finish to help prevent the evils of water and wear, but it isn’t a hard finish and thus required frequent re-application which was trying.
  • Shellac – Shellac is made from the residue of the lac bug of India. Shipped worldwide in lac “flakes”, and mixed with denatured alcohol until the flakes are dissolved and then applied to the wood surface and allowed to dry. While useful on furniture and trim, it was not the best on floors due to its delicate nature and its tendency to darken with wear and moisture. Often floors were shellacked and then had wax applied over top to protect the shellac.
  • Varnish – Varnish was an impressive improvement to wood finishes. It was discovered in the mid 18th century but didn’t really gain in popularity until after the Civil War. Compared to its predecessors, varnish is much harder and resists most anything. Tung and linseed oils were the principle varnish oils used as they penetrated the wood to provide for a relatively strong finish. The disadvantages of varnish is that they were slow drying compared to shellac and by todays standards provided a finish that was still fairly soft.
  • Polyurethane – Polyurethane was discovered in 1936 and became commercially available around 1940. Though this type of floor finish was not a part of most historic homes because of its late discovery, it by far the most common after-factory finish applied to wood flooring today. The reason? It dries relatively quickly, and most importantly, provides an extremely hard and durable surface that can last a decade or more without any care other than an occasional mopping. Polyurethane essentially creates an impenetrable layer of hard plastic over you wood floor. When applied properly, it is self leveling and very smooth. This is the preferred method of floor finishing we recommend even though not historically accurate because it maintains the wood and protects it against decay and wear more effectively than any of its predecessors.

Why Wood?

We’ll leave you with some parting thoughts if you are considering tiling over or carpeting over your antique wood floors…don’t! Of course, we can’t argue for one person’s decorating taste over another’s, but wood floors are a resilient flooring choice that will last hundreds of years if cared for properly. Even the finest carpet wears out after only a few years of traffic. Tile can chip when something is dropped on it and does’t respond well to the years of expansion and contraction that houses undergo. Vinyl can tear just by looking at it crossly! Wood flooring is long lasting, easily repairable (by a pro), and breathes with your house over the years.

Nothing can compare to the warmth that wood floors add. There are a myriad of different species with different grain  patterns and colors and even more choices when you add in the option of stain. The Heart Pine floors in George Washington’s Mt. Vernon estate are still going strong after 250 years. If they were good enough for our founding fathers aren’t they good enough for the rest of us?

To see more photos of how we can repair and refinish your wood floors visit our portfolio.

Subscribe Now For Your FREE eBook!

40 thoughts on “A History of Wood Floors

  1. Trying to identify a thick felt-like paper from the late 1940s, which I think may be rosin felt paper underlayment for flooring. Can anyone tell me if rosin flooring papers were white at the time? Thanks, Peggy E.

  2. I’ve always loved learning about the history of things cause I find it fascinating to know how much has changed over the years. I believe this is a well written article. Thanks for the knowledge.

  3. I bought a homemade “butcher block” workbench (24×24) that used 2″x 3/4″ tongue and groove oak flooring for the top set on their sides. Any idea of what year-span/decade used 2″ wide tongue and groove oak flooring? The 4×4 legs look like fir, and the framing around the top said Missouri.

  4. So, were heart pine floors covered with wall to wall carpeting during the Victorian era? I know critics argued for painted floors also during this time, as well as encaustic tile. My house has oak hardwood floors downstairs, I assume added during a 1902 remodeling, but all the floors upstairs are pine plank that is tongue and groove and stained darker around the perimeter office the rooms and hallways. The house was built in 1875.

  5. Greetings we bought an 1810 house in eastern Ohio that has the original wood floors. Unfortunately past home owners have painted some floors, and stained others a honey color and carowted over others. The floors are 2″ thick and range from 6-12″ wide and about 15′ long. They are quater-sawn square edge. Having found a mahogany color on floorboards and door trim we we’re wondering if you think the floors would also be that color. We are currently hand sanding the floors in one room and stuck at what color to finish the floors. Thanks for your help.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.